Grizzly G0634X, Руководство пользователя

Страница: 29 / 68

Model G0634X (Mfd. Since 11/20)
-27-
Jointer Depth-of-Cut Scale
The depth of cut can be referenced directly from
the depth scale located on the front of the jointer,
as shown.
Note: The depth scale can be calibrated or
"zeroed" if it is not correct. Refer to
Calibrating
Depth Scale for more information.
Figure 28.
Location of jointer depth-of-cut scale.
Depth Scale
Pointer
Depth Scale
Setting Jointer
Depth of Cut
The depth of cut on a jointer is the amount of
material removed from the bottom of the work-
piece as it passes over the cutterhead.
The depth of cut is set by adjusting the height of
the infeed table relative to the carbide inserts at
TDC (top dead center).
The jointer depth-of-cut scale (see Figure 27)
goes up to
3
⁄
16
", however the recommended depth
of cut per pass is
1
⁄
16
"–
1
⁄
8
" depending on the
operation.
Adjusting Infeed Table Height
To adjust infeed table height:
1.
Loosen infeed table height lock, rotate infeed
table height adjustment knob, then tighten
table height lock to secure (see Figure 27).
— Rotate infeed table height adjustment
knob clockwise to raise table.
— Rotate knob counterclockwise to lower
table.
Item Needed Qty
Hex Wrench 6mm .............................................. 1
Figure 27.
Location of jointer depth-of-cut scale
and infeed table height adjustment controls.
Jointer
Depth-of-Cut
Scale
Infeed Table
Height Lock
Infeed Table Height
Adjustment Knob
DO NOT exceed the recommended depth of
cut per pass, or kickback and serious injury
may occur.