Grizzly G0634X, Руководство пользователя

Страница: 22 / 68

-20-
Model G0634X (Mfd. Since 11/20)
To assemble machine:
1.
Remove shaft lock knob and insert cutterhead
guard shaft into bracket hole, as shown in
Figure 18
.
2.
Move fence forward until it touches cutterhead
guard.
3.
Thread lock knob into bracket so threads fit
into shaft groove (see Figure 18), and secure
guard into place. Adjust guard and lock knob
as needed so guard fully covers cutterhead.
4.
Test guard by pulling it back and letting go.
Rubber bumper on guard should hit fence
when guard comes back.
— Guard should snap back over cutterhead
without dragging across table.
— If guard drags across table, raise it until it
does not drag, then tighten shaft lock.
— If guard does not snap back, remove it and
repeat Steps 1–3.
Figure 18
. Installing cutterhead guard.
Groove
Bracket
Shaft Lock
Knob
Removed
Cutterhead
Guard
Dust Collection
Minimum CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
To connect dust collection hose:
1.
Fit 4" dust hose over jointer dust port, (see
Figure 19
), or over planer dust port (see
Figure 20
), depending upon operation mode,
and secure in place with hose clamp.
Figure 19.
Example of dust hose attached to
jointer dust port.