Grizzly G0603X, Руководство пользователя

Страница: 46 / 72

-44-
G0603X 25" Extreme Series Planer
Outfeed Roller
Tension
Tools Needed: Qty
Hex Wrench 4mm .............................................. 1
Wrench 14mm ................................................... 1
The amount of tension or downward pressure of
the outfeed roller needs to be enough to pull the
workpiece along the planing path without binding,
and prevent snipe to the end of the workpiece
by keeping it firmly on the planing table. Tension
requirements will be different for rough lumber
and milled lumber.
To adjust infeed roller tension:
1. DISCONNECT THE PLANER FROM
POWER!
2.
Remove the top right and left access panels
and identify the infeed roller tension springs
(see
Figure 44
).
Figure 44.
Outfeed roller tension spring (left side
shown; top right access panel removed).
Outfeed Roller
Tension Springs
Adjusting Hex Nuts
Note:
To reduce the tension, lengthen the
spring. Conversely, to increase the tension,
shorten the spring (see
Figure 43
on
Page
43 ).
3. Replace both access panels.
Pressure Bar
Tension
Tools Needed: Qty
Hex Wrench 8mm .............................................. 1
Wrench 14mm ................................................... 1
The amount of tension or downward pressure
of the pressure bar must be enough to keep the
workpiece firmly on the planing table as it exits
the cutterhead to prevent snipe, but not enough
to bind or gouge the workpiece. Tension require-
ments will be different for rough lumber and milled
lumber.
To adjust infeed roller tension:
1. DISCONNECT THE PLANER FROM
POWER!
2.
Lift the headstock cover and identify the pres-
sure bar tension spring (see
Figure 45 ).
Figure 45. Pressure bar tension spring (right
side shown).
Adjusting
Cap Screw
Pressure Bar
Tension Spring
Jam Nut
3.
Loosen the jam nut and adjust the cap screw
(see Figure 45 ).
Note: To reduce the tension, lengthen the
spring. Conversely, to increase the tension,
shorten the spring (see
Figure 43 on Page
43
).