Grizzly G0600, Руководство по вставке

Страница: 66 / 113

G0600 20" x 60" Big Bore Lathe
-63-
V-Belts
To adjust or replace the V-belts on the lathe:
1. DISCONNECT LATHE FROM POWER!
2. Open rear cover on the lathe base ( Figure
106
).
3.
Use a 24mm wrench and adjust the belt
tension hex nuts (see Figure 106 ) there is
approximately 10mm belt deflection on each
belt when pressed firmly in the center in
between the pulleys.
Note:
Replace all three belts as a matched
set even if one shows cracking, glazing, or
fraying.
4.
Reinstall the rear cover.
Brake and Switch
To adjust the brake and brake switch:
1.
DISCONNECT LATHE FROM POWER!
2.
Remove the side motor cover.
3.
Use a 16mm wrench and adjust the brake
rod ( Figure 107 ) so, when the foot pedal is
pressed, the brake band firmly clamps the
drum. When released the brake band should
be loose on the drum.
Note:
Replace the brake band when the fric-
tion material is worn down to approximately
2mm thick.
4. Use a 5mm hex wrench and adjust the brake
switch cam so when in the released position,
there is 3 to 5mm gap between the cam and
the brake switch pushrod (
Figure 107
).
5.
Reinstall safety cover and test foot brake
operation.
Figure 106.
V-belt adjustment.
Belt Tension Adjustment
Figure 107. Brake band and switch.
Brake Rod
3-5 mm
Gap
Brake Switch Cam
and Cap screw
After consistent lathe usage, it will be necessary
to compensate for brake lining wear.
After consistent lathe usage, it will be necessary
to compensate for belt wear.
������
����������
������