Grizzly G0600, Руководство по вставке

Страница: 48 / 113

G0600 20" x 60" Big Bore Lathe
-45-
Figure 60. Shoulder washer positioning.
Shoulder
10. Slide the 57-tooth gear onto the lower spin-
dle, install the shoulder washer on the spindle
so the shoulder faces the gear (
Figure 60 ),
and install the cap screw.
11. Using the 6mm hex wrench, remove the
upper spindle cap screw, spacer washer, the
48-tooth gear, and the spacer (
Figure 63 ).
12. Slide the spacer onto the spindle, then the
48-toothed gear with the shoulder facing the
spacer (
Figure 61 ). Install the spacer wash-
er, and secure with the cap screw.
13. Using a 24mm wrench, loosen the adjust-
ment arm locknut (
Figure 62
), and let the
adjustment arm swing away.
Figure 62. Center gear adjustment arm.
14. Install the center gear and spindle onto the
adjustment arm, then finger tighten the spin-
dle.
15. Move the center gear and adjustment arm
assembly, then tighten the spindle and adjust-
ment arm lock nut so all gears mesh and
have 0.0015" to 0.004" of backlash.
16.
Rotate the gears by hand to make sure no
binding occurs, and then paint the gear teeth
with general purpose automotive grease.
17.
When you are finished, make sure the gear
arrangement matches the ( V ) mode arrange-
ment shown in
Figure 56.
18.
Close the side cover and refer to the
Threading Chart on Page 40 for how to shift
your lathe to the appropriate feed or thread
pitch.
Adjustment Arm Locknut
Center Gear Assembly
Spindle
Adjustment Arm
Figure 61. Upper spindle gear and spacer
positioning.
Shoulder
Spacer