Grizzly G0555XH, Руководство пользователя, Страница: 23 / 72

Model G0555XH (Mfd. Since 1/18)
-21-
9. Thread (2) M10-1.5 knobs onto trunnion bolts
hanging through bottom of trunnion base, as
illustrated in
Figure 18.
Figure 22. Installed positive stop bolt.
10. Install table insert (see Figure 19).
11. Attach table gap screw assembly with (1)
M8-1.25 hex nut and (1) 8mm flat washer
(see
Figure 19), then tighten gap screw.
Note: Check this screw often to ensure table
surface is flush across gap.
Figure 19. Table insert and gap screw installed.
12. Install fence support using (2) M6-1 x 12
cap screws and (2) 6mm flat washers
(see
Figure 20).
Figure 20. Fence support installed.
x 2
Fence Support
Table Insert
Gap Screw
Assembly
Figure 18. Table installed on trunnions.
Trunnion Base
Knob
Table
Trunnion
13. Attach fence rail using (2) M6-1 x 20 hex
bolts, (2) 6mm lock washers, and (2) 6mm flat
washers (see
Figure 21).
Figure 21. Fence rail attached to table.
Positive Stop
14. Thread M8-1.25 hex nut halfway onto M8-1.25
x 100 hex bolt (this is the positive stop bolt).
15. Thread positive stop bolt into threaded hole
on bandsaw body as shown in
Figure 22.
Fence Rail
x 2