Grizzly G0510ZW, Руководство пользователя

Страница: 43 / 56

Model G0510ZW (Mfd. Since 9/16)
-41-
Shaper Conversion
Use these procedures to convert the Model
G0510ZW from a router table to a shaper.
The Model G0510ZW can still use shaper cutters
without removing table spacers, but you may not
be able to use full profile of all cutters with table
in this position.
Tools Needed: Qty
Spindle Wrench 26mm ...................................... 1
Open-End Wrench 14mm .................................. 1
Wrench/Socket 19mm ....................................... 1
Open-End Wrench 8mm.................................... 1
Open-End Wrench 13mm .................................. 1
To convert router table assembly to a shaper:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar guard from beneath table to
access taper nut.
3. Remove any router bits installed in collet.
4. Remove table and table spacers from the
shaper by loosening bolts securing table in
place.
5. Replace table with original mounting bolts
removed when converting shaper for use as
a router table.
6. Insert spindle/drawbar assembly into spindle
cartridge.
7. Thread drawbar nut onto bottom of drawbar
with taper side-up.
8. Tighten taper nut by holding another wrench
on spindle flats, as shown in Figure 60.
Figure 60. Tightening taper nut to install shaper
cutter spindle (pulley guard removed for clarity).
Spindle Flats
Taper Nut
9. Re-install drawbar guard.