Grizzly G0510ZW, Руководство пользователя

Страница: 20 / 56

-18-
Model G0510ZW (Mfd. Since 9/16)
9. Use (2) 8mm flat washers and star knobs to
secure fence assembly to table (see Figure
13).
10. Mount fence faces to fence assembly with (4)
M8-1.25 x 12 Phillips head screws, (4) 8mm
flat washers, and (4) M8-1.25 hex nuts, as
shown in
Figure 13.
Note: Heads of screws must be below sur-
face of fence face.
12. Inspect entire length of both fences to ensure
they properly align with each other.
— If the fences do not properly align with
each other, they must be shimmed or
resurfaced on a jointer.
Note: This is an important step. If the fences
will not properly align with each other, you will
not get accurate cuts.
13. Insert mounting post into post bracket on
rear of shaper table, and tighten star knob to
secure mounting post (see
Figure 15).
14. Secure attachment bar to mounting post
with (2) M8-1.25 x 12 hex bolts and (2) flat
washers (see
Figure 15).
15. Attach safety guard to bar with (2) M4-.7 x 10
Phillips head screws and (2) M4-.7 hex nuts.
Completed safety guard assembly should
look similar to
Figure 15.
11. Place a straightedge against fence faces, and
align them as close as possible using fence
offset knob (see
Figure 14).
Figure 14. Checking fence alignment with
straightedge.
Fence
Offset
Knob
Straightedge
Figure 13. Mounting fence faces to fence
assembly.
x 2
x 4
AMPUTATION HAZARD!
Safety guard reduces risk
of accidental contact with
rotating cutter and protects
operator from flying debris.
It MUST be installed.
IMPORTANT: Once setup, the safety guard height
adjusts by loosening the star knob that secures
the mounting post. Always position the safety
guard as close to the cutter as possible without
interfering with your work.
Figure 15. Safety guard components correctly
assembled on shaper.
Star
Knob
Guard
Attachment
Bar
Mounting
Post