Grizzly G0510ZW, Руководство пользователя

Страница: 30 / 56

-28-
Model G0510ZW (Mfd. Since 9/16)
2. Rub collar above cutter: Cut cannot be
seen during operation when rub collar is
above cutter (see
Figure 33). However, this
offers some advantage—stock is not affected
by slight variations in thickness and acciden-
tal lifting will not damage workpiece. Simply
correct any change in height by repeating
operation.
3. Rub collar between two cutters: Using
rub collar between two cutters offers distinct
advantage of performing two cuts at once or
eliminating a need to change cutters for two
different operations (see
Figure 34). Notice
that part of your workpiece edge remains
uncut and rides along rub collar.
Figure 33. Cutting with rub collar above cutter.
Figure 34. Using rub collar between cutters.
Above
Rub Collar
Above
Cutter
Rub
Collar
Rub Collar
Between
Cutters
Irregular Shaping
Irregular or freehand shaping takes a high degree
of skill and dexterity. The fence assembly is not
used in irregular shaping, so rub collars
must
be used. Refer to Rub Collars on Page 27 for
details.
When doing freehand work, a starting pin
must be used! The purpose of the starting pin
is to support the workpiece during the beginning
of the cut. Your shaper is supplied with two start-
ing pins that can be placed in either of the holes
located in the shaper table. Your work should be
placed in the starting position, using the starting
pin for support, as illustrated in
Figure 35.
Figure 35. Always feed against cutter rotation.
Workpiece
Feed Direction
Swing
Starting Pin
Rub
Collar
Ro
tation
Freehand shaping greatly increases chance
that operator may lose control of workpiece;
therefore, use a starting pin to increase
control while freehand shaping. Loss of
control could result in loss of fingers or
other serious personal injury.