Grizzly G0510Z, Инструкция по эксплуатации

Страница: 36 / 45

G0510Z 3⁄4 HP Shaper -33-
Pulley Alignment
Tools Needed: Qty
Wrench/Socket 12mm ....................................... 1
Dead Blow Hammer .......................................... 1
Hex Wrench 4mm .............................................. 1
Improper pulley alignment sharply reduces the
effectiveness of power transmission and belt life
expectancy.
To align the pulleys:
1.
DISCONNECT SHAPER FROM POWER
SOURCE!
2. Remove the spindle pulley cover.
3. Visually check the alignment of the belt while
moving the spindle elevation through its full
range of motion. If the motor pulley is in
proper alignment with the spindle pulley, the
belt should never move higher or lower than
the upper and lower limits of the motor pul-
ley.
— If the belt does move higher or lower than
the upper or lower limits of the motor
pulley, then the motor pulley must be
adjusted.
4.
Align the motor pulley by loosening the
setscrews and tapping the pulley into the
desired position with a dead blow hammer.
5.
Tighten the setscrews and replace the spin-
dle pulley cover after the pulley is aligned.
Truing the Fence
To ensure that the fence is parallel with itself
and square with the table:
1.
Ensure that the bolts through the wood fac-
ing on each side are tight and adequately
countersunk.
2.
To align the wood facing, adjust one or both
fence halves so they are in close alignment.
Micro-adjust and check the alignment with a
straightedge.
3. If the wood fences are not coplanar with
each other, resurface as one unit. You can
perform this operation on a jointer as shown
in
Figure 42
.
NOTICE
Make sure the screws are countersunk deep
enough so the workpiece will not come
in contact with the heads of the screws!
Check the screw depth after each pass to
ensure that the screws will not contact the
knives!
Figure 42.
Resurfacing fences on a jointer.