Grizzly G0510Z, Инструкция по эксплуатации

Страница: 34 / 45

G0510Z 3⁄4 HP Shaper -31-
5.
Gently tap the bottom of the drawbar to knock
the spindle loose.
6. Remove the spindle/drawbar assembly from
the spindle cartridge.
7.
Place the desired collet into the collet nut by
pushing it in until it snaps (see Figure 38 ).
8.
Insert the collet into the spindle cartridge and
tighten the collet nut until the collet is flush
with the top of the collet nut, as shown in
Figure 39 .
Figure 38.
Collet snapped into collet nut.
9.
Place the table spacers over the table mount-
ing holes on the shaper.
10. Place the table on the spacers and secure
it to the shaper with the hex bolts from the
router table spacer kit (see
Figure 40 ).
Figure 39. Collet flush with top of collet nut.
11.
Save the removed table bolts for when you
need to covert the Model G0510Z back to use
as a shaper.
���������
������������
�������
�����
Figure 40.
Installing table spacers to convert
shaper to a router table.