
G0501 Sliding Table Saw
-35-
Fence Scale
Alignment
Before operation, the 0" mark on the rip fence
scale must be aligned with the right side of the
blade to ensure that the rip fence measurements
will be accurate.
To align the fence scale with the blade:
1.
Set the blade to 0˚ on the control panel (90˚
with the cast iron table).
2.
Raise the main blade up as far as it will go.
3.
Disconnect the saw from the power source!
4.
Remove the stop bolt shown in
Figure 56
.
Figure 56.
Rip fence stop bolts
Figure 58.
Rip fence scale lock knob.
5.
Move the rip fence all the way against the
blade as shown in
Figure 57
.
7.
Move the fence away from the blade and re-
install the stop bolt that was removed in
step
4
.
Figure 57.
Rip fence aligned with blade.
6.
Loosen the scale lock knob (
Figure 58
),
adjust the scale 0" mark even with the fence,
and tighten the scale knob to keep the scale
in place.
Содержание G0501
