Grizzly G0501, Инструкция по эксплуатации, Страница: 4 / 109

G0501 Manual Update
-3-
Installing Extension
Tables
To install the extension tables:
1.
Thread the M6-1 x 70 hex bolts through the
center of the hollow hex bolts and into the
holes in the bottom of the extension table as
shown in
Figure 4 .
Figure 5. Attaching the braces.
5.
Get an assistant to position the small exten-
sion table over the holes on the cast iron
table, then secure it with three M8-1.25 x 20
hex bolts, lock washers, and flat washers.
Figure 4.
Installing the hollow hex bolts.
2.
Thread an M16-2 hex nut and a flat washer
onto each hollow hex bolt.
3. Place the braces over the hollow hex nuts,
followed by another flat washer and hex nut
(see
Figure 5 ).
Note: Do not fully tighten the braces. The
tables will need to be leveled when installed.
4. With the help of two assistants, install the
large extension table with four M8-1.25 x 20
hex bolts, lock washers, and flat washers as
shown in
Figure 6
.
Note:
The table saw may have been shipped
with the bolts and washers needed for table
installation already threaded into the holes in
the cabinet.
Figure 6.
Large extension table installed.