Grizzly EXTREME G0513X, Руководство пользователя, Страница: 3 / 92

G0514X2/G0514X3 Manual Insert
-3-
Guide Post Handwheel
Secure the guide post handwheel onto the flat
part of the handwheel shaft with the included set
screw, as shown on G0514X/G0514X3 Manual
Page 33
in
Figure 39
.
Installing Foot Brake
Components and Hardware Needed: Qty
Sliding Plate ...................................................... 1
Cap Screws M6-1 x 15 ..................................... 2
Lock Washers 6mm ........................................... 2
To install the foot brake:
1. Secure the foot pedal to the brake lever using
the cap screws and lock washers, as shown
in
Figure 5 .
Figure 5
. Foot brake installed.
Foot Brake (Operations)
Use the brake only in emergency situations to
stop power from going to the motor and bring the
blade to a halt.
The foot brake will not stop the bandsaw
wheels and blade instantly. DO NOT become
over confident and relax your safety aware-
ness because of the foot brake feature.
Personal injury or death
can occur if the bandsaw
starts during table adjust-
ment. Disconnect power
from the bandsaw before
performing table adjust-
ments.
3. To tilt the table to the right, turn the table tilt
handwheel clockwise (
Figure 6
).
4.
To tilt the table to the left, turn the table tilt
handwheel clockwise one turn, lower the
positive stop bolt, then turn the handwheel
counterclockwise.
5. Secure the table tilt lock lever ( Figure 6 ).
6. Follow "Positive Stop" instructions for resett-
ting the stop bolt and table for horizontal (0º)
operations.
Figure 6. Table tilt controls.
Lock Lever
Table Tilt
Handwheel
Table Tilt
The bandsaw table will tilt 5˚ left and 45˚ right to
provide a wide range of cutting options.
To tilt the table:
1. DISCONNECT BANDSAW FROM POWER!
2. Loosen the table tilt lock lever shown in
Figure 6
.