Grizzly EXTREME G0513X, Руководство пользователя, Страница: 2 / 92

-2-
G0514X2/G0514X3 Manual Insert
2.
Thread the M8-1.25 hex nut halfway onto the
M8-1.25 x 90 hex bolt (this is the positive stop
bolt).
3.
Thread the positive stop bolt into the thread-
ed hole on the bandsaw body.
4. Lower the table onto the positive stop bolt.
To set the positive stop: (See Page 24, G0514X/
G0514X3 Manual)
4.
Raise the guide post and place a machinist’s
square on the table next to the side of the
blade as illustrated in
Figure 20
on G0514X
Manual Page 24 . Adjust the table square with
the blade, then secure with the table tilt lock
lever (
Figure 6 ) on Page 3 .
Table Tilt Assembly
Components and Hardware Needed Qty
Sliding Plate ...................................................... 1
Hex Bolts M6-1 x 10 .......................................... 2
Flat Washers 6mm ............................................ 2
Table Tilt Handwheel ......................................... 1
Hex Bolt M8-1.25 x 50 (Preinstalled) ................ 4
Hex Nut M8-.1.25 (Preinstalled) ........................ 1
Flat Washers 8mm (Preinstalled) ...................... 2
To attach the table tilt assembly:
1.
Tilt the table up and secure the table lock
lever.
2. Remove the hex bolt, hex nut and flat wash-
ers installed on the geared table tilt tube
(
Figure 2 ).
3.
Secure the sliding plate to the table tilt tube
with the fasteners removed in Step 2 , making
sure the hole closest to the edge of the plate
is installed on the left side of the table—fac-
ing the rear of the bandsaw.
4.
Lower the table onto the positive stop bolt.
5.
Secure the table tilt handwheel onto the flat
part of the handwheel shaft with the included
cap screw (
Figure 3
).
Figure 2
. Table tilt assembly.
Table Tilt
Tube
Hex Bolt
Figure 3
. Table tilt handwheel installed.
Cap Scew
6.
Raise the sliding plate up and secure it to the
bottom of the table with the hex bolts and flat
washers, as shown in
Figure 4
.
Figure 4
. Sliding plate secured to table.
Sliding Plate
Hex Bolt
Hex Bolt