Jade
can operate without DMX signal (in AUTOMATIC mode) and can be set so that a single MASTER unit will
command a series of SLAVE units. This function is particularly useful when more units are desired to execute the
same programme in synchrony.
The following picture shows an example of a Master-Slave layout.
6.1 MASTER configuration
The projector can perform a pre-set colour-changer programme.
In order to perform such pre-set programme please refer to the chart below:
The projector will perform a flash if you select a time of 5 seconds, 2 flashes for 10 seconds, 3 flashes for 20 scond
and 4 flashes for 40 seconds.
6.2 SLAVE configuration RGBW
To set up the unit as SLAVE set the 5 channels DMX mode with address 001.
6.3 SLAVE configuration Dynamic white
To set up the unit as SLAVE set the 3 channels DMX mode with address 001.
MASTER
SLAVE 1
SLAVE N
IN
OUT
IN
OUT
SLAVE 2
IN
OUT
Terminal resistor
(R=120
ƺ
not included!)
6.0 Master-Slave and Automatic function
Funzione
Tasti
Descrizione
Master Con-
figuration
AV
the input or the removing of the automatic mode can be performed only after
the log in. The pre-set time of each scene is 5 seconds. If the projector is turned
off when it is set in automatic mode, it will switch on again in automatic mode
with the same selected scene time.
Increase of
the scene
duration
P+
Available only if the projector is set in automatic mode. Increase of the scene
time: 5 – 10 – 20 – 40 seconds.
Decrease
of the
scene du-
ration
P-
Available only if the projector is set in automatic mode. Decrease of the scene
time: 40 – 20 – 10 – 5 seconds.
Warning!
If MASTER-SLAVE mode is being used, no other DMX control device must be present along the line!!
English
23
