Gripe Rite GR309EDV, Руководство по эксплуатации и список запасных частей

Страница: 9 / 22

SET UP PROCEDURE
WARNING:
Before being operated with pressurized tanks for the first time, your new compressor requires
a simple set-up procedure that will help your unit deliver years of trouble-free service. Failure
to follow all initial set-up instructions may result in serious damage to your compressor,
property damage, or serious injury to operator and bystanders. Do not allow compressor to
pressurize tanks until all set-up steps have been performed.
1. Read the manual and all warning labels on the
unit.
2. Check compressor oil level, and fill as needed.
(See #9 below)
3. Open the tank drain cocks (A), or outlet valve.
4. Start the compressor (see page 9), and run the
compressor for 20 minutes with drain cock
open to lubricate the bearings and pistons.
5. After 20 minutes, close the drain valve or outlet
valve.
6. Compressor is now ready for normal,
pressurized operation.
7. After first 24 hours of operation, check V-belt
tension. Correct tension setting is 1/2” of
slack when measured at midpoint between
pulleys.
8. Check bolts and nuts periodically and tighten
when necessary.
9. Check oil level at sight glass (B). Oil level must
be maintained between “L” (Low) and “H” (High)
indicator lines. To add oil, remove oil filler
plug (C) and fill until sight glass shows proper
level. Change oil after first 100 hours of
operation. Add non-detergent mineral oil to
compressor.
10. Use chart below for correct viscosity:
Air Temperature Viscosity
3 – 32
°
F (16 - 0
°
C) SAE 10W (ISO 32)
34 – 79
°
F (1 - 26
°
C) SAE 20W (ISO 68)
80
° F
& Up (2
°
C) SAE 30W (ISO 100)
11. Replace oil filler plug before starting
compressor.
8