Gripe Rite GR309EDV, Руководство по эксплуатации и список запасных частей

Страница: 19 / 22

TROUBLESHOOTING
PROBLEM CAUSE REMEDY
Loose compressor or motor Tighten mounting bolts
Excessive discharge pressure Reduce operating pressure
Compressor not level Level compressor
Leg bolt tightened too tight Loose leg bolts
Wrong oil being used Drain and replace with proper oil
Loose flywheel, drive pulley, or drive
belt Tighten parts and check belt
tension. Tighten belt if needed.
Excessive vibration
Worn rods, wrist pin, or main
bearings Check and replace worn parts
Compressor valves loose or broken Check and replace worn or
broken valves Compressor knocks
Inspect check valve for low
pressure knock Remove and clean check valve
Clogged inlet filter Clean or replace filter
Wrong oil or viscosity being used Drain and replace oil
Oil level too high Drain oil to proper level
Crankcase breather valve
malfunction Replace crankcase breather
valve
Compressor runs unloaded too long Increase load or stop compressor
when not needed
Compressor operating in cold
conditions - inlet filter not protected Provide protection against
extreme weather conditions
Worn piston rings Replace piston rings
Compressor uses too much oil
Piston rings not seated See below
Allow 100 hours of normal operation
for new rings to seat Piston rings not seated
Drain oil and refill with approved
compressor oil
Pressure switch misadjusted Have authorized service dealer
adjust pressure switch. Safety relief valve pops open
Pressure switch inoperable Have switch serviced by
authorized service dealer.
Air leaks from safety relief valve Valve stuck or inoperable Pull on ring and release.
Replace valve if leak continues.
18