Grindmaster FDD2500-1-3A-B, Руководство по обслуживанию

Страница: 9 / 36

Model FDD2500 Page 9
Cleaning (cont.)
Weekly Cleaning (cont.)
Cleaning Hoppers – Disassembly Cleaning Hoppers – Reassembly
CAUTION: Do not wash hopper without first
disassembling.
IMPORTANT : All components must be completely dry prior
to reassembly.
1.
Open door, disconnect large hose from
funnel cover and then lift off funnel
cover.
1.
Place driveshaft bearing inside hopper
with threads going through hole in the
rear of the hopper.
2.
Lift off ring heater and set aside.
2.
Secure the bearing by attaching the palnut
to the bearing outside rear hopper opening. Use
one hand inside the hopper to push
the bearing outward while turning the
palnut clockwise.
3.
Lift open lid and remove coffee spill
pan.
4.
Remove the hopper from the cabinet.
3.
Install the auger spring driveshaft
and the auger spring by inserting the
flat end of the spring into the
5.
Remove the hopper
cover and empty
hopper contents.
4.
Insert assembly into lower front hopper
opening, making sure the threaded end of
the auger spring driveshaft completely
inserts into the plastic driveshaft bearing in
the rear of the hopper. The driveshaft
bearing threads should be accessible
6.
Remove the auger pinwheel by pulling it
forward while stretching out the sides of
the hopper.
5.
Place the washer over the driveshaft
bearing threads followed by securing
the drivelink onto the driveshaft bearing
by turning counterclockwise. Secure
the auger spring with one hand while
attaching the drivelink with the other.
7.
Remove the drivelink and washer at
the rear of the hopper by holding the
auger spring with one hand at the front
of the hopper while turning the drivelink
clockwise with the other hand.
6.
Replace the auger pinwheel making sure
the pins are securely positioned inside the
locator holes in the hopper.
8.
Remove the auger
spring and auger spring
driveshaft by pulling out
through the lower front open-
ing of the hopper.
7.
Carefully fill
the hopper
with product
and replace
the cover.
9.
Remove the palnut at the
rear of the hopper by turning
it counterclockwise then remove
the driveshaft bearing from the
inside of the hopper.
8.
Reinstall hopper into the
machine, making sure it is
properly aligned.
10.
All parts in contact with food must be washed, rinsed,
sanitized, and air dried.
1
Install ring heater to front spout.
Open lid and install coffee
spill pan.
Driveshaft
Bearing

PULL
Auger Spring
Driveshaft
9.
10.
Install funnel cover with large
tube attached.