Grindmaster FDD2500-1-3A-B, Руководство по обслуживанию

Страница: 7 / 36

Model FDD2500 Page 7
Programming Machine from Touchpads (cont.)
24) Press (>) to Retrieve Error Codes. (20A) (cont.)
SC4: Thermistor Failure (Temperature is out of range – less than 32°F or greater than 210°F.)
SC6: Check Heating (Tank is too hot.)
SC8: Overcooling
SC9: Overflow (Water level safety probe is tripped.)
SC10: Adjust Temperature (Temperature adjusted from touchpad.)
25) Press (>) for Clear Error Code options. (20B)
Press (+) or (-) to toggle between YES (clears all stored error codes from memory) and NO.
Important : After selecting YES and then pressing (>) all data will be cleared immediately.
26) Press (>) for EXIT option
Press (+) or (-) to toggle between YES and NO.
Important: After selecting YES, you MUST press (>) to SAVE changes, or wait for READY message and machine
will exit without saving.
FILLING PRODUCT HOPPERS (see Figure 4)
1) Open door.
2) Lift hinged top.
3) Remove hopper lid.
4) Carefully pour product into hopper.
5) Replace hopper lid.
6) Lower hinged top.
7) Close door.
THERMOSTAT ADJUSTMENT
( See machine programming procedure: Water tank temperature)
Tools required: None
NOTE: The thermostat range is approximately 40°F to 205°F (4°C to 96°C). The water tank temperature is factory set
at 190°F (87°C), making the beverage temperature slightly lower than 190°F (87°C).
HOW TO DISPENSE A DRINK
Machine is equipped to dispense into cups, decanters, 1.3 L servers, 2.2 L airpots or hose connected to 5 gal. containers.
WARNING : Server must rest flat on tray with a 1/4" (6 mm) clearance between cup and spout. Contents can cause
severe burns if handled improperly.
For Manual Machines FDD2500-1-M-B and FDD2500-3-M-B:
1) Place a server under the selected drink dispense nozzle.
2) Pull dispense handle until cup is 2/3 full, then release handle.
For Automatic Machines FDD2500-1-3A-B and FDD2500-3-3A-B:
1) Place a server under the selected drink dispense nozzle.
2) Press and release desired dispense button.
NOTE: To stop a dispense, simply press-and-release any button.
Figure 4
WARNING : Disconnect power before servicing machine.