INSTALLATION
4
UNLOADING & MOVING
Using a Crane
The Infiernos are modular and travel in large crates. The
modules may be lifted while still in the crates using straps rated
to at least 5,000 lbs. They also may be lifted after the crate is
removed using the same type of straps. The modules are very
top and backheavy due to the large amount of fire brick lining
the floor and back. TAKE THIS WEIGHT DISTRIBUTION
INTO ACCOUNT WHEN LIFTING THE GRILL.
Using a Forklift
You may use a pallet jack once the Infierno been removed
rom the delivery vehicle. Whether inside or removed from
the crate, make sure to lift from the back, positioning the jack
under the center of the grill spread as wide a possible. TAKE
WEIGHT DISTRIBUTION INTO ACCOUNT. The grill
weighs over 5,000 lbs, make sure the forklift is rated to lift well
in excess of this weight.
Using a Pallet Jack
You may use a pallet jack once the Infierno has been removed
from the delivery vehicle. Whether inside or removed from
the crate, make sure to lift from the back, positioning the jack
under the center of the grill spread as wide a possible. ONLY
USE ON A FLAT SURFACE MOVING THIS GRILL ON
AN INCLINE WITH A PALLET JACK IS NOT SAFE AND
CAN CAUSE INJURY OR DAMAGE TO PROPERTY OR
THE GRILL.
NEVER PUT THE INFIERNO ON ITS BACK, FRONT OR
SIDE! SIGNIFICANT DAMAGE TO COMPONENTS OF
THE GRILL CAN OCCUR. USE GREAT CARE WHEN
MOVING AN INFIERNO.
IF YOU HAVE ANY QUESTIONS OR CONCERNS
CONTACT GRILLWORKS AT (855) 434-3473. BE SAFE!
CLEARANCES
The Infierno should be installed with 2” clearance to
noncombustible materials near the back of the unit. The sides
should have 6” of clearance in case the gear lift system needs
to be reached (if the unit is ordered on wheels this may be
reduced to 4”) The front of the unit must have at least 36”
clearance to other equipment or walls for proper operation.
WARNING DO NOT PACK REQUIRED AIR SPACES
WITH INSULATION OR OTHER MATERIALS. The grill is
adequately insulated and the best outer insulator is free
air space.
Only install the Infierno on a non-combustible floor. This non-
combustible floor must extend at least 48” at the front of the
unit, 36” at the sides and 48” at the rear (if the grill is installed
exposed at the back). If installed as a built-in (without legs) the
base it is installed on must also be non-combustible.
THE ENTIRE AREA OVER THE INFIERNO MUST
BE NONCOMBUSTIBLE EXTENDING 48” IN ALL
DIRECTIONS (IF NOT ENCLOSED) AND THE GRILL
MUST BE INSTALLED UNDER A SUITABLE TYPE 1
SOLID FUEL HOOD SYSTEM.
ANY FACADE MATERIALS AROUND THE GRILL MUST
BE NON-COMBUSTIBLE.
IF THIS GRILL IS NOT PROPERLY INSTALLED A FIRE
MAY RESULT. A MAJOR CAUSE OF GRILL RELATED
FIRES IS A FAILURE TO MAINTAIN REQUIRED
CLEARANCES (AIR SPACES) TO COMBUSTIBLE
MATERIALS. IT IS CRITICAL THAT THE
INFIERNO GRILL BE INSTALLED BY A QUALIFIED
PROFESSIONAL AND ONLY IN ACCORDANCE WITH
THESE INSTRUCTIONS. WARNING: DO NOT PACK
AIR SPACES AROUND GRILL WITH INSULATION.
ALERT: Installation, operation and servicing of this
appliance can expose you to ceramic dust. ALWAYS
WEAR PROTECTIVE EYEWEAR AND RESPIRATORY
PROTECTION AS A PRECAUTION AGAINST
INHALATION OR EYE INJURY.
Infierno 240 Tigre/166/100
®
Installation & Use