33
TROUBLE SHOOTING
PROBLEM
SOLUTION
When I light the grill it, does
not flame immediately.
-- Make sure you have turned on the gas.
-- Make sure it a spark while you are trying to ignite the burner.
-- Push in control knob and turn to ignite/preheat and hold for approximately 5 seconds
and then ignite the grill.
-- Make sure your burner is clean.
Regulator makes noise.
-- Vent hose on the regulator may be plugged or regulator may be faulty.
-- Make sure the vent hole on the regulator is not obstructed. Clear the hole, close the LP
cylinder and gas control valves. Wait 10 minutes and re-start.
-- When turning the LP cylinder valve on, do not cover vent hole on the regulator.
-- Check your flames for proper performance if the flames are not correct then replace
regulator.
-- Purge The lines.
Grill only heats to 200-300
degrees.
-- Ensure the temperature gauge is functioning properly. Hold a flame to the probe or
compare the grill gauge to an oven thermometer placed in the grill.
-- Ensure correct start procedure. Prior to lighting grill, the gas control knobs should be
off. The propane bottle should be off. If not, wait 15 minutes. Turn cylinder all the way
on. Turn left burner to ignite, wait 5 seconds to ignite. Repeat for additional burners.
-- Check all gas connections for leaks with bubble test. If leaks are found, replace the
part or tighten the fitting.
SPIDER AND INSECT WARNING!!!
Spiders and insects can nest in the burners of the grill
and cause the gas to flow from the front of the burner.
This is a very dangerous condition, which can cause a
fire to occur behind the valve panel, thereby damaging
the grill and making it unsafe to operate.
WHEN TO LOOK FOR SPIDERS
You should inspect the burners at least twice a year or
immediately after any of the following conditions occur:
Содержание SRGG42004
Страница 9: ...9 EXPLODED VIEW...
