14
15
REMOVABLE PROTECTIVE CHIN GUARD
3. Removable Protective Chin Guard Release
3.1.
Open the visor completely.
3.2.
Pull the right chin guard release lever upwards and at the same time remove
the chin guard from the helmet by pulling it outwards (Fig. 6). Perform the same
operation on the left side of the helmet.
WARNING
Every time you wish to release the chin guard to use your helmet in the jet configura-
tion, insert the right and left chin guard locking slot covers (chin guard covers) in the
slots on the right and left side frames and push them towards the inside of the helmet
until you hear a fastening click (Fig. 7).
NOTE: The left and right chin guard covers are different from each other and are
marked on their back as R (Right) and L (Left).
4. Removable Protective Chin Guard Fastening
Before fastening the chin guard to the helmet, remove the chin guard covers by per-
forming the following operations:
4.1.
Open the visor completely.
4.2.
Pull the right release lever upwards and at the same time remove the chin guard
cover by pulling it outwards (Fig. 6). Perform the same operation on the left side
of the helmet.
4.3.
Insert the right end of the chin guard into the right side frame slot of the helmet
and press it towards the inside of the helmet until you hear a fastening click (Fig.
7). Perform the same operation on the left side of the helmet.
4.4.
Make sure the chin guard is correctly fastened at both ends by gently pulling it
towards the outside of the helmet.
WARNING
-
Never remove the semi-rigid inner padding of the chin guard.
-
When the helmet is used without the removable protective chin guard, always
assemble the chin guard covers supplied.
-
If in doubt on how the manual chin guard release device works, please contact a
Grex dealer.
•
(Available as standard or accessory/spare part).
5. Inner Visor PINLOCK
®
Assembly
5.1
Disassemble the visor (see instructions above).
5.2
Make sure that the inner surface of the visor is clean and check that the pin ad-
justment external levers are turned inwards (Fig. 10).
5.3
Place the PINLOCK
®
inner visor on the visor.
WARNING: The silicone-sealed profile of the PINLOCK
®
inner visor must be in
contact with the inner surface of the visor.
5.3
Insert one side of the PINLOCK
®
inner visor on one of the visor pins and hold it
in position (Fig. 8).
5.4
Widen the visor and fasten the other side of the PINLOCK
®
inner visor to the
second pin (Fig. 9).
5.5
Release the visor.
Содержание G4.2 PRO
Страница 52: ...Fig 1 Fig 2 Fig 4 Fig 3 Fig 5 Fig 6 Fig 7 A C B...
Страница 53: ...Fig 8 Fig 10 Fig 12 Fig 11 Fig 9 Fig 13 A Fig 13 B MIN MAX D E...
Страница 54: ...Fig 14 Fig 16 Fig 18 Fig 17 Fig 15 Fig 19 Fig 20 Fig 21...
Страница 55: ...Fig 22 Fig 23 A Fig 23 B...
