GREMSY H3, Руководство пользователя

Страница: 27 / 35

REMOTE CONTROL
RECEIVER CONNECTION
gStabi supports SBUS, SPEKTRUM and PPM receivers. There are some parameters to be
aware of before assigning channels to the receiver.
SMOOTH: increasing this number will smooth out the movement of the corresponding
axis but will also cause a delay.
SPEED: increasing this number will increase the speed of movement in the correspond -
ing axis. Only applicable in Speed Mode.
SPEED MODE: when speed mode is selected, the speed of the corresponding axis will
depend on how far the stick position is from the neutral position. It is recommended that
TILT and PAN channels should be set to speed mode.
ANGLE MODE: when angle mode is selected, the corresponding axis will move to the
angle set by current stick/knob position. It’s recommended ROLL channel should be set
to angle mode.
Simply connect SBUS/PPM wires from the receiver to the SBUS/PPM connector of the gStabi controller.
SBUS/PPM SETTINGS
24
“SBUS/PPM”
RECEIVER
SBUS/PPM
NOTES:
The SBUS/PPM port has 5V out -
put to power the receiver, please do not
use external power supply to power the
receiver at the same time. Doing so may
damage the electronic inside the gimbal.