29
MAINTENANCE
Disconnect chainsaw from power supply.
Rotate the chain cover lock knob counter-clockwise, and remove knob.
Remove the chain cover.
Remove the bar and chain from the mounting surface.
Remove the old chain from the bar.
Lay out the new saw chain in a loop, and straighten any kinks. The cutters should face in the
direction of chain rotation. If they face backwards, turn the loop over.
Place the chain drive links into the bar groove as shown.
NOTE: Make certain of direction of chain.
Position the chain so there is a loop at the back of the bar.
Hold the chain in position on the bar, and place the loop around the sprocket.
NOTE: When placing the bar on the bar studs, ensure that the adjusting pin is in the chain tension pin hole.
Replace the chain cover.
Replace the chain cover lock knob. Rotate knob clockwise to tighten. The bar should still be
free to move for tension adjustment.
Remove all slack from the chain by turning the chain tensioning knob clockwise until the chain
seats snugly against the bar with the drive links in the bar groove.
Lift the tip of the guide bar up to check for sag.
Fig. 24
Fig. 23
THUMB ON
UNDERSIDE OF
HANDLE BAR
CHAIN
COVER
BAR
CHAIN
CHAIN COVER
LOCK KNOB
MOUNTING
SURFACE
Содержание 20012
