English (Original Instructions)
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
ENVIRONMENTAL PROTECTION
■
Environmental protection should be a priority of
considerable importance when using the machine,
for the benefit of both social coexistence and the
environment in which we live. Try not to cause any
disturbance to the surrounding area.
■
Scrupulously comply with local regulations for the
disposal of packaging, deteriorated parts or any
elements with a strong environmental impact; this
waste must not be disposed of as normal waste,
it must be separated and taken to specified waste
disposal centres where the material will be recycled.
■
Scrupulously comply with local regulations for the
disposal of waste materials after mowing.
■
At the time of decommissioning, do not pollute the
environment with the machine, but hand it over to a
disposal centre, in accordance with the local laws in
force.
REPLACING THE CUTTING BLADE
See figure 10-11.
NOTE:
Only use authorised replacement blades. Replace
worn or damaged blades and bolts in sets to preserve balance.
■
Stop the motor and release the switch box handle.
Allow blade to come to a complete stop.
■
Remove the battery pack.
■
Turn the mower on its side.
■
Wedge a block of wood between the blade and mower
deck to prevent the blade from turning.
■
Loosen the blade bolt by turning it counterclockwise
(as viewed from bottom of mower) using a 27 mm
wrench or socket (not provided).
■
Remove the blade bolt and blade.
■
Place the new blade on the shaft. Ensure blade is
properly seated with shaft going through center blade
hole and the two blade posts on the fan inserted into
their respective holes on the blade. Make sure it is
installed with the curved ends pointing up toward the
mower deck and not down toward the ground. When
seated properly, the blade should be flat against the
fan.
■
Thread the blade bolt on the shaft and finger tighten.
■
Torque the blade bolt down clockwise using a torque
wrench (not provided) to ensure the bolt is properly
tightened. The recommended torque for the blade bolt
is 62.5~71.5 kgfcm (350-400 in.-lb.).
5