3
Cleaning Kit
Available online at
www.greenwayhp.com
Figure A
OPERATING INSTRUCTIONS
Initial Product Cleaning Procedure
As with most new appliances, it is recommended to clean the reservoir
prior to first time use.
1
. Make sure the unit is unplugged and all power switches are turned off.
2
. Remove the bottle support collar, saturate a clean cloth with water
dispenser cleaner or vinegar and wipe the inside of the reservoir.
3
. Pour water dispenser cleaner or a mixture of 0.3 gal / 1 L of vinegar
with 0.3 gal / 1 L of hot water into the reservoir and wait 20 minutes.
IMPORTANT: To avoid water overflow while cleaning the dispenser,
always remove the bottle support before pouring water or cleaning
solution into the reservoir. (See Figure A).
4
. Press all dispensing buttons until water no longer comes out.
5
. Drain the reservoir from the drain outlet on the back of the unit.
6
. Rinse again with clean water.
7
. Place bottle support collar back on top of dispenser.
Maintaining Your Water Dispenser
Like most appliances, your new water dispenser requires regular cleaning to operate efficiently.
Your water dispenser must be cleaned every 4 months (see procedure on page 6).
Installing the Water Bottle
IMPORTANT: Always wash your hands first! Clean the top (neck) of the bottle with a clean cloth and
do not touch the part of the unit that the water touches. Make sure the unit is unplugged and all power
switches are in the OFF position. The water bottle can be purchased from your local retailer.
1
. Remove the protective cap from the end of the water bottle unless the bottle has a puncturable
cap or sticker.
2
. Lift and turn the bottle upside down, placing securely on the bottle support collar.
3
. Press and hold all dispenser buttons until water flows from the dispenser. Drain about 0.3 gal / 1 L of
water before initial use. This does not need to be repeated with replacement bottles.
4
. Plug in the water dispenser.
5
. Set all the power switches at the rear of the dispenser to the ON position.
6
. Ready-to-dispense indicator light will come on when water reaches optimum temperatures and is
ready for use.
