8
BPI Module Replacement
WARNING: Make sure to disconnect the unit from its power source
before any maintenance or cleaning is done.
Your BPI Module should be replaced every year.
See Page 9 for Replacement Part Numbers.
1. Disconnect unit from power source.
2. Remove the Cover’s two screws along the top
edge with a #1 Phillips-Head screw driver.
3. Tilt the Cover away from the top of the unit.
4. Remove the Black Grille by sliding it out.
5. Disconnect BPI Module’s black and white wires
from lever connectors (orange/clear).
6. Remove screws securing the BPI Module to
the unit and remove Module.
7. Install new BPI Module, securing it to the unit
with screws.
8. Cut black and white wires to length that
will reach the lever connectors, leaving
sufficient length to strip back insulation
from end of wires ½”.
9. Connect black and white wires from BPI Module to the lever connectors.
Make sure the connections are black to black and white to white.
10. Replace the Black Grille.
11. Close and secure the Cover of the Unit.
12. Reconnect unit to power source.
