ENGLIS
H
5
1
13. If the electric power tool stops and the overload indicator (2) is lit continuously,
then the overload protection of the electric power tool has responded. Reason:
You were moving forward too quickly or have encountered an obstacle in the
workpiece. In this case, switch off the electric power tool and inspect the
workpiece. Move forward at a slower speed.
Line Cuts
You can follow a drawn line with the help of the indicator marks (a), at the front and
rear of the safety guard. For precise work, the relationship between the saw cut and
a marked indicator line must be established using a test piece. The ideal positioning
of the saw cuts must then be achieved by adjusting the indicator line to the target
line.
Working with Large Workpieces
When working with large workpieces or cutting straight edges:
•
Use fastening clamps to tighten a board or border onto the workpiece as an
auxiliary stop.
•
Guide the left-hand side of the base plate along the auxiliary stop.
Plunge Cuts (Figure 1)
Note:
Some very hard materials are not suitable for plunge cuts.
1.
Put the base plate on the workpiece. Make sure that the rear lateral depth
marking is at the height of the beginning of the cut.
2.
Switch on the electric power tool and allow a couple of seconds to pass until the
tool insert reaches its full speed. Then plunge the tool insert, slowly but with
some pressure.
3.
Push the electric power tool forwards through the workpiece.
4.
When you reach the end of the cut, switch off the electric power tool and pull it
out of the workpiece.
Cutting Tiles
Adhesive tape or insulation tape on the workpiece makes the work easier and helps
to prevent it from getting scratched.
After Use:
1.
Switch of the tool.
2.
Remove the plug from the socket.
3.
Let the tool cool down.
4.
Remove all accessories such as saw blades.
Changing the Batteries (Pic.6)
The laser works with 2 button cells GPA76. As soon as the laser stops working you
have to replace the batteries.
•
Remove the lid of the battery compartment (11).
•
Remove the old batteries.
•
Replace with new batteries.
•
Place the lid on the battery compartment (11).
Never dispose of old/empty batteries within your household rubbish but take them
to a special waste area.
There are no inner parts of the tool which need maintenance.
(17)
