Greentec HL152- 242 Cutterbar
12
•
Be particularly careful when working under high voltage cables. Keep a distance
of at least 10 m from high voltage cables.
•
If you run into an obstruction, you must stop the hedge trimmer immediately and
check it for damage.
•
Before getting down from the vehicle, you must place the hedge trimmer on the
ground, remove the ignition key and secure the vehicle, to prevent it from rolling.
•
The hedge trimmer may carry on running after it is switched off. Wait until it has
stopped entirely.
•
During work breaks you should place the hedge trimmer on the ground and
install the Blade Guard and safety guards.
•
With hydraulically activated parts there is a risk of body parts becoming crushed
and unclipped.
•
The hydraulic installation may be under pressure.
•
Liquids (hydraulic oil) that are under great pressure and seep out may penetrate
the skin and cause serious personal injury. In the event of personal injury, you
should seek the help of a doctor immediately, as there is a risk of infection.
•
Only connect hydraulic hoses when the hydraulic installation is free of pressure.
•
Check the hydraulic hoses regularly for leakage, damage and ageing. Damaged
hydraulic hoses must be replaced promptly. The new hydraulic hoses must meet
the manufacturer’s technical requirements.
•
Oil leaks pose a hazard to the environment. Hydraulic oil seepage must be
collected and disposed of in the proper manner.
•
Use protective goggles when looking for leakages.
Safety information for assembly, maintenance and repair work
•
Mounting, maintenance and repairs must be carried out exclusively by authorised
and qualified specialists.
•
Work on the machine may only be carried out when the machine is stationary.
Always follow the procedure for stopping that is described in the manufacturer’s
instruction book.
•
Wear close-fitting clothes and use the necessary personal protective equipment.
•
If you have to carry out maintenance on the hedge trimmer while it is raised, it
must be secured with a suitable support.
•
Release the pressure in the hydraulic installation before starting any works on
the hedge trimmer.
•
Some of the hedge trimmer’s parts may be very hot. Allow the hedge trimmer to
cool off.
•
Handle and dispose of oils and grease in accordance with the rules.
•
All safety and protective devices must be installed or activated again immediately
after a work session is finished.
•
When starting up the machine again, you must follow the instruction book from
the tool carrier or vehicle manufacturer.
Содержание HL 152
Страница 1: ...GreenTec HL152 242 Cutterbar 3 1 edition 2020...
Страница 2: ...Greentec HL152 242 Cutterbar 2...
Страница 46: ...Greentec HL152 242 Cutterbar 46 Bilag 1 Tightening torques...
Страница 47: ...Greentec HL152 242 Cutterbar 47...