32
MOMENTUM T7 TREADMILL
MAINTAINENCE
HOW TO MAINTAIN THE MOMENTUM T7 TREADMILL
:
Proper maintenance is very important to ensure y our treadmill is always in top working condition. Improper maintenance could
cause damage or shorten the life of your treadmill and exceed any WARRANTY coverage.
•
Important
: Nev er use abrasives or solv ents to clean the treadmill. To prevent damage to the computer, keep liquids away
and keep it out of direct sunlight.
•
Inspect and tighten all parts of the treadmill regularly. Replace any worn parts immediately.
BELT ADJUSTMENT
:
Belt adjustment and tension performs two f unctions: adjustment for tension and centering. The running belt has been adjusted
properly at the f actory. Howev er transportation, unev en f looring or other unpredicted reasons could cause the belt to shift off center
resulting in the belt rubbing with the plastic side rail or end caps and possibly causing damage. To adjust the belt back to it’s
proper position please f ollow the directions below:
•
Walking belt has shifted to the left
:
First unplug the power cord f rom the surge protector. Using the hex key provided,
turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the surge
protector and run the treadmill at 2.5 mph. Y ou should see the belt start to correct itself, mov ing back towards the center.
Repeat the above procedure until the walking belt is centered. It may be necessary to set walking belt tension once y ou
hav e completed this procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping"
instructions.
•
Walking belt has shifted to the right:
First unplug the power cord f rom the surge protector. Using the hex key provided,
turn the right rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the surge
protector and run the treadmill at 2.5 mph. Y ou should see the belt start to correct itself, mov ing back towards the center.
Repeat the above procedure until the walking belt is centered. It may be necessary to set walking belt tension once y ou
hav e completed this procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping"
instructions.
•
Walking belt is slipping
:
First unplug the power cord f rom the surge protector. Using the hex key provided, turn both the
left and right rear roller adjustment bolts the same distance, usually a 1/4 turn in the clockwise direction. Plug the power
cord back into the surge protector and run the treadmill at 2.5 mph. Y ou should now walk on the belt to determine if the
belt is still slipping. Repeat the above procedure until the walking belt is not slipping. The tension should be just tight
enough not to slip.
WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!
Right and left tension bolts are located at the rear of the treadmill.
