EK628 Battery-powered Crimping Tool
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
6
Operation
Electric shock hazard:
This tool is not insulated. When
using this unit near energized
electrical lines, use proper personal
protective equipment.
Failure to observe this warning
could result in severe injury or
death.
Wear eye protection when operat-
ing or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Keep hands away from the crimp-
ing head when crimping.
Failure to observe this warning
could result in severe injury or
death.
This tool is not designed for continuous use. After
30 to 40 crimping cycles, allow the crimping tool
to cool for 15 minutes.
Do not place the tool in a vise. The crimping tool
is designed for hand-held operation.
This tool may be used in damp or wet environ-
ments, however, we recommend air drying the
tool before use if it becomes soaked. Damage
may result when the tool is operated prior to
drying out when electrical components are
soaked.
Use this tool for the manufacturer’s intended
purpose only.
Failure to observe these precautions may result in
injury or property damage.
•
•
•
•
Charging the Battery
Read the instructions supplied with the battery
charger.
LED Display
This tool is equipped with a special circuit board
incorporating several important features to inform
the user about the current status of the unit. The LED
signals in the following cases:
