GreenDS GDS+ 3, Руководство пользователя

Страница: 21 / 24

GreenDS
Auto Fault Computer Diagnostic Equipment
20
5.Vehicle Diagnosis
5.1 Connection of OBD-II connector
Choose the proper connectors according to the
diagnostic connectors of the to-be-detected vehicles.
If the connector of the to-be-detected vehicles is
standard OBD-II, you need to connect the two ends
of the main test wire with the main unit and OBD-II
connector separately, fasten them with bolts and put
diagnostic connector into the diagnostic sockets on
one side of the vehicle.
5.2 Connection of Non-OBD-II Connector
At first, you should confirm that whether the
connector of to-be-detected vehicle has the GDS+ 3
decoder. In connecting, you should firstly connect the
connector that is exclusive to GDS+ 3 decoder to
standard OBD-II connector, and then connect
standard OBD-II connector with the main test wire
and the main unit of the decoder.
5.3 Steps of Vehicle Diagnosis
1, Find the location of vehicle diagnostic socket.
2, Select the connector according to the vehicle
diagnostic socket model.
3, Connect the main unit to the wire or connector of
the to-be-detected vehicle.
4, Connect the testing connector to the vehicle
diagnostic socket as shown in Figure 5.2A.
Note: If the power supply of diagnostic socket of
diagnostic vehicle is insufficient or its power supply
pin is damaged. You can make the decoder obtain
power supply by any of the following ways:
1
）
Through the cigarette lighter cord: insert one
end of cigarette lighter cord to automobile
cigarette lighter hole, the other end of the
GreenDS main testing line connect to power
plug.
2
）
Through the double-clamp power cord: connect
power clamp of double-clamp power cord to the
battery positive and negative, insert the other
end into the GreenDS main testing line power
plug.
5. Select the diagnostic program according
to different vehicle.