71
Technical Information
Service Manual
is set. Do not put the remote contro ller near the object of high
temperature or low temperature in order to avoid detecting
inaccurate amb ient temperature. When I FEEL function is turned
on, the remote controller should be put within the area where
indoor unit can receive the signal sent by the remote controller.
CLOCK
button
Press this button to set clock time. " " icon on remote controller
will blink. Press "▲" or " ▼ " button within 5s to set clock time.
Each pressing of "▲" or " ▼ " button, clock time will increas e or
decrease 1 minute.If hold "▲" or " ▼ " button, 2s later, time will
change quickly. Release this button when reaching your required
time. Press "CLOCK" button to confirm the time. "
" icon stops
blinking.
Note:
● Clock time adopts 24-hour mode.
● The interval between two operation can't exceeds 5s.
Otherwise, remote controller will quit setting status. Operation for
T-ON/T-OFF is the same.
SLEEP
button
Under COOL or HEAT mode, press this button to start up sleep
function.
" " icon is displayed on remote controller. Press this button
again to cancel sleep function and " " icon will disappear.After
powered on, Sleep Off is defaulted. After the unit is turned off, the
Sleep function is canceled.
In this mode, set temperature will be adjusted with the change
of time. Under Fan, DRY and Auto modes, this function is not
available.
WiFi
button
Press " WiFi " button to turn on WiFi function, "WiFi " icon will
be displayed on the remote controller; Hold " WiFi " button for 5s
to turn off WiFi function and " WiFi " icon will disappear.
Under off status, press "MODE" and " WiFi " buttons
simultaneously for 1s, WiFi module will restore factory settings.
Note:
● This function is only available for some models.
button
Press this button to achieve the on and off of health and
scavenging functions in operation station. Press this button
for the first time to start scavenging function; LCD displays
" ". Press the button for the second time to start health and
scavenging functions simultaneously; LCD displays " " and " ".
Press this button for the third time to quit health and scavenging
functions simultaneously. Press the button for the fourth time to
start health function; LCD display " ". Press this button again to
repeat the operation above.
● This function is applicable to partial of models .
LIGHT
button
Press this button to turn off display light on indoor unit. " " icon
on remote controller disappears. Press this button again to turn
on display light. " " icon is displayed.
TEMP
button
By pressing this button, you can see indoor set temperature,
indoor ambient temperature or outdoor ambient temperature on
indoor unit's display. The setting on remote controller is selected
circularly as below:
● When selecting "
" or no display with remote controller,
temperature indicator on indoor unit displays set temperature.
● When selecting "
" with remote controller, temperature
indicator on indoor unit displays indoor ambient temperature.
● When selecting "
" with remote controller, temperature
indicator on indoor unit displays outdoor ambient temperature.
Note:
● Outdoor temperature display is not available for some models.
At that time, indoor unit receives " " signal, while it displays
indoor set temperature.
● It's defaulted to display set temperature when turning on the
unit. There is no display in the remote controller.
● Only for the models whose indoor unit has dual-8 display.
● When selecting displaying of indoor or outdoor ambient
temperature, indoor temperature indicator displays corresponding
temperature and automatically turn to display set temperature
after three or five seconds.
