Gree U-Match 5 Series, Руководство пользователя

Страница: 128 / 224

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
125
Removal of condenser
Note: Before removing the condenser, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
3. Remove motor support.

When removing the motor
support, be careful to protect the
components.
4. Remove the condenser.

Heat up the welding points of
connection pipes through gas
welding until the pipes break off.
Note: When welding the pipes,
do not let the flame burn the
other components. The welding
points of condenser are steel and
copper welding points. Be sure to
maintain the welding quality.
5. Take out the condenser.

Loosen the securing screws of
condenser support. Take off the
plate type heat exchanger and
the support as a whole.
6. Install the new condenser.

Secure the screws of condenser
and support. Then fix them
together on the chassis.

Install the condenser by referring
to the positions of entering and
leaving pipes. Weld the
connection pipes.

Nitrogen welding: the pressure of
nitrogen is 0.5±0.1kgf/ c
㎡
(relative pressure).
Note: When welding the pipes,
do not let the flame burn the
other components.