13
Technical Information
Service Manual
1. Combination of "MODE" and "
▲
" buttons:
About switch between Fahrenheit and centigrade
2. Combination of "TEMP" and "TIMER" buttons:
About Energy-saving Function
3. Combination of "TEMP" and "TIMER" buttons:
About 8
℃
Heating Function
4. WIFI Function
At unit OFF, press "MODE" and " ▲ " buttons simultaneously to switch between
℃
and
℉
.
Press "TEMP" and "TIMER" simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays "SE". Repeat the operation to quit the function.
Press "MODE" and "TURBO" button simultaneously to turn on or turn off WIFI function. When WIFI function is turned on, the "
WiFi
" icon will
be displayed on remote controller; Long press "MODE" and "TURBO" buttons simultaneously for 10s, remote controller will send WIFI reset
code and then the WIFI function will be turned on. WIFI function is defaulted ON after energization of the remote controller.
● This function is only available for some models.
Press "TEMP" and "TIMER" simultaneously in HEAT mode to start 8
℃
Heating Function Nixie tube on the remote controller displays " "
and a selected temperature of "8
℃
".
(46
℉
if Fahrenheit is adopted). Repeat the operation to quit the function.
Function introduction for combination buttons
Replacement of batteries in remote controller
1. Press the back side of remote controller marked with " ", as shown in the fig, and then push out the cover of battery box along the
arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
signal sender
battery
Cover of battery box
remove
reinstall
