)XQFWLRQDQG&RQWURO
5HSODFHPHQWRI%DWWHULHV
TIMER:
8
Combination of "+"
and "-" buttons: About lock
9
Combination of "MODE " and "-" buttons: About switch between fahrenheit and cenrigrade
10
Combination of "+" and "FAN" buttons: About Lamp
11
Press this button to initiate auto-on/auto-off timer. To cancel auto-timer program, press this button twice.
Press "+" and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller is locked, is displayed.
In this case, pressing any button, blinks three times.
At unit OFF, press "MODE" and " - " buttons simultaneously to switch between °C and °F .
Under switch-on or switch-off state, you may hold "+" and "FAN" buttons simultaneously for 3 seconds to set the lamp on or
off and send the code. After being energized, the lamp is defaulted on.
ƾ
●
●
●
●
●
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
When replacing the batteries, do not use old or different types of batteries,
If the remote controller will not be used for a long time, please remove batteries
otherwise, it may cause malfunction.
to prevent batteries from leaking.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
Notes:
Fig.1
Fig.2
4. Reinstall the battery cover plate.
If the remote controller does not operate normally, please take the batteries
out and reinsert them after 30 seconds. If it still can't operate properly,
replace the batteries.
