5
24℃
-7℃
27℃
43℃
21℃
18℃
Notices for use
Anti-cool wind function:
In "Heat" mode, under the following three kinds of state, if indoor heat exchanger
doesn't arrive at certain temp., indoor fan will not act, in order to prevent cool wind
blowing(within 2 mins):
1. Heating starts 2.After Auto Defrost finished 3.Heating under the low temperature
The conditions of unit can't normally run
The following temperature range protection device may act, that may cause stop running.
"HEAT"
running
Outdoor temp.
above
Outdoor temp.
below
Indoor temp.
above
"COOL"
running
Outdoor temp.
above
Indoor temp.
below
"DRY"
running
Indoor temp.
below
Under the relative humidity above 80% (doors and windows opened) when cooling or
dehumidifying for a long time, there will be dew dripping off near the air outlet.
Gentle Breeze
In the following situation, the indoor unit may blow gentle breeze,
and the guide louver rotate to a certain position:
1. In “Heat” mode, the unit turned on, the compressor doesn’t arrive the starting condition;
2. In “Heat” mode, the temperature arrive at the setting value and the compressor
stop running about 1min.
*
Under COOL mode, when selecting and entering "Auto Quiet Design" function, within the
initial 10mins, the noise may loud.
Quiet Design:
*
This function could be used and arranged in pairs with air conditioner and also could be
used under no unit starting condition for sole use, the detailed introduction please
Air Exchange:
refer to the operation method "Air Exchange" of remote control. The other notices
please refer to "Operation and installation guidelines for independent air exchange
device".