2
6
Installation Manual
Electrical wiring
How to connect wiring to the terminals
A. For solid core wiring (or F-cable)
(1) Cut the wire end with a wire cutter or wire-cutting pliers, then stuip the insulation to about 15/16” (25mm) of expose
the solid wire.
(2) Using a screwdriver,remove the terminal screw (s) on the terminal board.
(3) Using pliers, bend the solid wire to form a loop suitable for the terminal screw.
(4) Shape the loop wire properly, place it on the terminal board and tighten securely with the terminal screw using a
screw driver.
B. For strand wiring
(1) Cut the wire end with a wire cutter or wire-cutting pliers, then strip the insulation to about 3/8” (10mm) of expose
the solid wire.
(2) Using a screwdriver, remove the terminal screw (s) on the terminal board.
(3) Using a round terminal fastener or pliers, securely clamp a round terminal to each stripped wire end.
(4) Position the round terminal wire, and replace and tighten the terminal screw using a screwdriver.
C. Attention:
An all-pole disconnection switch having a contact separation of at least 3mm in all poles should be connected in fixed wiring.
A. Solid wire
Loop
Insulation
Screw with
special washer
Round
terminal
Terminal
board
Wire
Round
terminal
Wire
Strip 15/16” (25 mm)
Screw with
special washer
Round
terminal
Strip 3/8” (10 mm)
B. Strand wire
Fig.11
