GREAT PLAINS Yield-Pro PL5800, Руководство оператора

Страница: 43 / 111

Great Plains | 411-474M | 12/17/2019 36
PL5800 Planter Table of Contents Index Operation
Fertilizer Ground Drive Lock-up
Sharp Object and Crushing Hazard
The force required to left the wheel is 90 lbs
(41 kg). If you lose your grip before pinning
or after pinning, the arm snaps down rapidly.
The traction teeth and force of the wheel
impact can inflict serious injury. Do not left
or lower the wheel by a spoke or rim, use
the handle only.
When not using the fertilizer ground drive, preserve
the pump by locking up the ground wheel.
Do not operate the pump when not applying
material.
To lock up the fertilizer drive:
1. Remove the clevis pin from the storage hole (3).
2. Release the lock arm (4).
3. Lift the handle (5) to left the ground wheel up and
position it in the between lock arm.
4. Secure with clevis pin (6) and cotter pin.
Fertilizer Hydraulic Drive
The fertilizer hydraulic drive uses a fixed
displacement pump driven by hydraulic motor under
seed monitor control. Refer to the monitor manual for
instructions.

Height Switch
The height switch informs the seed monitor if the
planter is raised or lowered. On all planters, the
monitor only counts seed when the planter is
lowered and the drive is activated. On hydraulic and
electric drive planters, the height switch also enables
or disables the drive.
When the hydraulic drive planter is raised,
the switch state is ignored during FILL DISK
and 5 REV TEST operations.
To adjust the height switch:
Loosen the bolts holding the height switch bracket
(1) and rotate the switch (2) and bracket away from
the frame pivot (3).
5. Lower the planter to the height at which seed
delivery should begin.
6. Rotate the switch toward the frame pivot until the
spring actuator (4) touches the frame.
It may be necessary to loosen the screws
holding the switch and rotate the switch
slightly on the bracket.
7. Rotate the switch in until it clicks. Tighten the
bolts to secure the bracket in place.
8. Make sure the frame tube will not crush the
switch when the unit is fully loaded.

Frame Mounted Row Accessories
Terra-Tine Row Cleaner Adjustment
All adjustments must be made with the unit in the
fully raised position.
Excess Wear Risk
Check that the Terra-Tine row cleaner tines
do not touch the coulter blade or any other
attachments. At least 3/8 inch (13 mm)
clearance is recommended. Tine contacts
cause excess wear to all parts involved.
1. With the blade out of the soil, adjust the lock
collar height to set the height of the tine fingers
flush with the bottom of the coulter blade.
2. For side-to-side alignment, rotate the shank
mount around the vertical shaft and tighten the
square head set screw.
3. For forward and backward adjustment, add or
remove the extension arm (1) to place the row
cleaner to either side of the coulter hub (2),
!
i
32364
6
3
5
4
i
23398
1
2
3
4
i
!