GREAT PLAINS Yield-Pro PL5800, Руководство оператора

Страница: 27 / 111

Great Plains | 411-474M | 12/17/2019 20
PL5800 Planter Table of Contents Index Operation
10. When unfolding is complete, tap the
FOLD
softkey again. The FOLD softkey will turn back to
gray. Tap the
Home
softkey.
11. Press the WORK SCREEN softkey.
12. Rephase the fold cylinders by moving and
extending the lever for an additional 30 seconds.
This causes the wings to push against the
tongue hooks.
It is necessary to rephase the fold system
rephasing cylinders so the wing gauge
wheels run in the fully rotated positions in
front of the planter.
13. Release the wing locks using one of these
procedures, depending on hitch type:

For 2-point hitch, lower the hitch to
disengage the wing locks.

For hydraulic hitch, press the
HITCH
softkey
under
Working Hydraulics
on the
FOLD
SEQUENCE
screen, and lower the hydraulic
hitch to disengage the wing locks.
14. Unfolding is complete when the roller on top of
the tongue is engaged by the tongue later (1).
Planter Damage Risk
Do not plant if the tongue latch is not fully
down over the roller. Frame and opener
damage is likely if the planter is operated
with the latch open.
15. With the planter still in full lift, remove the gauge
wheel cylinder channel locks, and store at the
front of each caster.
16. Lower the planter.
Folding
Fold the planter for moves between fields, transport
over public roads, parking, and storage.
For folding, the planter must be raised with lock
channels installed. The tongue is raised and lowered
during the sequence.
1. Set circuit levers for the seed box fan and
optional hydraulic meter drive to neutral.
2. Move the planter to level ground with adequate
overhead and side-to-side clearances for the fold
operation.
3. Put the tractor in park and/or set the park brake.
4. Make sure markers, if installed, are fully folded.
5. Activate the circuit lever to extend the lift
cylinders until the planter is fully raised.
6. Set the circuit lever to Neutral to hold at a lift.
7. Shut off the tractor and remove the key.
8. Remove the transport lock channels from
storage and put the channels on the transport
wheel cylinders.
i
1
71123
!