2018-06-06
151-144M
3P1006NT
Appendix B - Pre-Delivery
82
Caster Shaft Installation
Refer to Figure 54 and Figure 55
Begin Install Shaft
21. Select one each:
Insert caster shaft
through caster frame plate
and secure with bolt
and nut
.
Install Lock Out Plunger
22. Select one each:
Place lock out plunger spring
over lock out
plunger
. Inserting from the bottom up of plunger
tube
, force both into the plunger tube and secure
with roll pin
.
The lock out plunger tube
MUST be facing to the
front of the drill. If it is facing to the rear, the pivot arm
tube is on backwards and must be switched.
Finish Install Shaft
23. Select one each:
and two each:
Place spacer
over the top of the caster
shaft
. With mallet, drive one bushing
into
shaft hole on bottom of pivot arm tube and one in top
of hole on pivot arm tube. Place shaft up through
these bushings in pivot arm. Complete assembling
shaft by placing caster retaining cap
on top and
securing with two washer lock springs
and two
bolts .
Install Lock Tube
24. Select one each:
266-020D UHMW RND 2.0 DIA X 2.0 LONG
266-012D PLATE RND 3/16" THK 1 7/
Assemble bushing
, spring
and small round
plate
. Push up inside lock tube. Complete with
nut
and bolt
.
Install Caster Zerks
25. Select one:
Install zerk
in shaft at end of pivot arm tube.
26. Repeat all steps for other caster.
Figure 54
Caster Shaft Installation
32115
1
2
U
D
B
F
R
L
Figure 55
Caster Assembled
32119