9
STEP 12:
Position the unit as shown to mount the flat runners on the
RH faces of the panels.
Start with the central divider (C) and position 1x flat
runner (#10) as shown with the wheel at the front of the
unit on the lower edge. Fix in place with 2x runner screws
(#9). When in place the runner will be level with the front
of panel C.
Now attach 1x flat runner (#10) to the RH side panel (D),
again with the wheel at the front and on the lower edge.
Fix in place using the holes shown with 3x runner screws
(#9). When in place the runner will sit back 15mm from the
front edge of panel D.
STEP 13:
Now mount the flat runners on the LH faces of the
panels.
Start with the central divider (C) and position 1x flat
runner (#11) as shown with the wheel at the front of
the unit on the lower edge. Fix in place with 3x runner
screws (#9). When in place the runner will be level with
the front of panel C.
Now attach 1x flat runner (#11) to the LH side panel (E),
again with the wheel at the front and on the lower edge.
Fix in place using the holes shown with 3x runner screws
(#9). When in place the runner will sit back 15mm from
the front edge of panel E.
Hardware for Step 13:
2x #11 Flat Runners
Hardware for Step 12:
2x #10 Flat Runners
#9
#9
#10
#9
#9
#10
#9
#9
#9
#11
#9
#9
#9
#9
#9
#9
#9
#9
#9
#9
#9
#9
5x #9 Runner Screws
C
D
C
E
6x #9 Runner Screws
Note:
It is important
to use the screw
holes shown or
your runners
will not sit in the
correct position.
R
emarque:
Il est important
d’utiliser les trous
de vis illustrés,
sinon vos glissières
ne seront pas
placées dans la
bonne position.
Hinweis:
Es ist wichtig,
die abgebildeten
Schraubenlöcher
zu verwenden,
sonst sitzen Ihre
Läufer nicht in der
richtigen Position.
Nota:
Es importante
utilizar los orificios
para tornillos
que se muestran
o las guías no se
asentarán en la
posición correcta.
GBR
FRA
DEU
ESP
