Service Mower - 50
SERVICE MOWER
5. Remove retaining ring (I), spindle shaft (J), lower
bearing (K) and spacer (L) from spindle housing (M).
Discard bearing.
6. Remove and discard upper bearing (N).
7. Clean entire assembly.
8. Install a new lower bearing (K) and spacer (L) on the
spindle shaft (J).
9. Install the spindle shaft (J), lower bearing (K) and spacer
(L) into the spindle housing (M).
10.Install the upper bearing (N) and retaining ring (I).
11.Install upper pulleys:
•
Right and Left Spindles (A): Install pulley (D),
spacer (C) and nut (B). Tighten nut to 81 N•m (60 lb-ft).
•
Center Spindle (E): Install spindle pulley (H), drive
pulley (G) and nut (F). Tighten nut to 81 N•m (60 lb-ft).
12.Install mower blade, blade washers and blade bolt
assembly. Tighten nut to 81 N•m (60 lb-ft). (See Checking
and Replacing Mower Blades.)
IMPORTANT: Avoid damage! The clearance between
the lower bearing and the housing is only 0.05 mm
(0.002 in.). Do not force bearing into housing.
Содержание Chariot / Chariot LX GDRZ48-17KAE
Страница 58: ...Service Electrical 54 SERVICE ELECTRICAL Wiring Schematic Carbureted Engines MX15338...
Страница 59: ...Service Electrical 55 SERVICE ELECTRICAL Wiring Schematic 26 HP Fuel Injected Engine MX15345...
Страница 60: ...Service Electrical 56 SERVICE ELECTRICAL Wiring Schematic 28 HP Fuel Injected Engine MX15356...