Jaguar II User Manual
Scale Length &
Width
This “Scaling” feature is used to adjust the error
on the length and width, which may cause by the
thickness of the media. The Denominator is
the actual length, and the Numerator is the ideal
length measured from the resultant. For
example, cutting a line with 500.0 mm length.
The procedure as follows:
1. Press the [LEFT ARROW] to choose the
Numerator and select 500.0 mm,
2. Cut the length by sending a graph file,
3. Measure the length then use the [RIGHT
ARROW] key to choose the Denominator
and,
4. Press [UP ARROW /DOWN ARROW]
changes the values to the actual length.
Set Smoothing Cut
Enable this feature to make curves smoother.
Set Tangential Mode
Provide the emulation tangential-cutting
technique with thicker media types and small
letter cuts.
Note: When the Offset value is setting at 0.000
mm Set Tangential Mode will automatically
setting at disable.
Disable
[Tool Select]
Pouncing
It makes perforated paper patterns that used
together with a charcoal or chalk pounce bag.
The patterns will allow you to transfer an image
to surfaces for hand painting or cutting.
Place pouncing strip on the top of the cutting
pad to protect the cutting pad during.
Setting Range: 0 mm – 200 mm, for 0 mm is
used to disable the pouncing mode.
* Pouncing tool is an optional item.
Description of Operation 3-6
