18
Control surface travels
Ailerons
10 mm up and down
)
Elevators
11 mm up and down
)
30% Exponential
Rudder
35 mm right and left
)
Please note that the stated control surface travels are just a starting point; you may
well wish to adjust them to suit your personal preference and flying style.
Important:
When fitting and adjusting the various linkages you should ensure that they move
freely, without binding, are able to move to their full extent - including trim travel - and
are not obstructed mechanically at any point.
When you move the rudder stick to the right, the rudder should also deflect to the
right (left stick: left rudder). Pull the elevator stick back towards you, and both
elevators must deflect up (stick forward: elevators down). If you move the aileron
stick to the right, the right aileron should rise, the left aileron fall. When you move the
throttle stick forward, the motor should run at full power; pull the throttle stick back for
idle. Move the throttle trim right back to its end-point, and the engine or motor should
stop reliably.
All that remains is to wish you many hours of pleasure flying your TAXI SPORT
II.
