GRAUPNER Micro Star 400, Руководство пользователя

Страница: 20 / 28

Micro Star 400 v2
20
Fit the two clamps 4441.311 and the servo mounts 4441.308 on the tail boom 4441.310, then
screw the vertical and horizontal stabilizers 4441.04 to the clamps. Draw the toothed belt
through the boom (taking care not to twist it), and push the tail rotor onto the end of the boom.
Install the tail rotor blades 4441.02 in the blade holders as shown in the drawing; check that
they swivel freely.
The tail boom is installed as shown in the illustration below:
Undo the four retaining screws from the chassis, and remove the bracket and front belt pulley.
Loosen the top section of the tail boom support to the point where the tail boom can be slid into
place (1).
Rotate the toothed belt through 90° in the direction shown (2).
Engage the belt pulley in the toothed belt, and re-fit the tail rotor drive assembly in the chassis
(3).
Pull the tail boom back to place the toothed belt under tension, then tighten the screws in the tail
boom support (4).