Quick start guide
(Please follow the instructions of the transmitter for more information)
S1012 Receiver GR-12L HoTT
Betrieb
1. Binding
• GR-12L
Turn on the receiver and press the bind button on the receiver for 3 seconds until the red
LED turns off.
Follow the instructions for binding your transmitter, the system will connect in a few se-
conds.
NOTE:
Check after binding by turning on / off the transmitter that the transmitter is atta-
ched to the receiver
2. Channel Mapping
To add an input channel to another channel output please call the menu on the transmitter
output on your transmitter.
3. Fail-safe-function
By default, keep in delivery condition of the receiver all connected servos in the event of a
fail-safe situation their last valid position in („Hold“ mode). In fail-safe case, the red LED on
the receiver. In addition, the transmitter will beep once per second for acoustic warning.
Take advantage of the safety potential of this option by programming at least for a fail-safe
position in case the engine throttle to idle, or the glow-motor function in electric models to
„stop“ or at Heli-models to „hold“. The model can then not do in case of failure so easily
and independently as to property or even cause injury.
Please also read the manual of your remote control system!
4. Out of range warning
Generally, a audible range warning is issued in the form of a beep, sounding approximately
once per second when the receiver signal in the feedback channel is too weak. Since the
transmitter, however, a considerably higher transmission power than the receiver has, the
model can still be operated safely. For safety‘s sake you should however reduce the model
distance until the signal stops again.
Not the aural warning despite low (est) distance, the lower voltage or temperature alert the
transmitter or receiver is active! In this case, the model operation is stopped immediately
and load the appropriate battery.
Seite 1 Graupner S/J
