GRAUPNER/SJ GmbH D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
03/2013
5
Snip off the projecting screw shanks using side-cutters. Protect your eyes!
Tape the control surfaces at neutral, and mark the correct length of the pushrods at
the servo output arms. Bend the rods at right-angles at the marked point and snip off
the excess material, leaving about 1 mm projecting when the pushrod keepers are in
place.
The wing is retained on the fuselage using rubber bands which are stretched
between two aluminium dowels. Fit the dowels through the holes in the fuselage and
centre them (equal projection on both sides). Secure them with a few drops of
cyano.
Drill a central 1 mm Ø hole in the underside of the fuselage for the towhook. Screw
the hook into the hole, and secure it with a drop of cyano.
