GRAUPNER/SJ GmbH D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
03/2013
3
The next step is to pull off the rudder and elevator, and glue the hinges in place using
UHU-ALLESKLEBER Kraft. The adhesive should be applied sparingly to avoid an
accumulation of glue at the pivot line. The gap between the fixed and moving panels
should be about 0.5 mm.
Prepare the rudder and elevator servos by pressing the rubber grommets and metal
spacers into the mounting lugs; these parts are supplied with the servos.
The pictures show how the grommets and spacers are fitted to the servos.
Remove the servo output levers, cut them down to the shapes shown in the pictures,
and fit them on the servos again; don’t forget the output screws. Check from the
transmitter that the servos are at centre (neutral) when the output arms are fitted on
the shafts. The servos can now be fitted in the fuselage. Each is secured using four
self-tapping screws, which are also included in the servo accessory packs.
